This Installation Guide provides the basic installation, wiring and programming information required to program the PowerSeries PC1616, PC1832 and PC1864 control panels. This guide shall be used in conjunction with the PowerSeries PC1616/1832/1864 Reference Manual

Section 1 Installation & Wiring This Installation Guide provides the basic installation, wiring and programming information required to program the PowerSeries PC1616, PC1832 and PC1864 control panels.

Smoke alarms should be installed outside of each sleeping area and on each level of the home. DSC recommends that additional smoke alarms beyond those required for minimum protection be installed. Additional areas that should be protected include: the basement;...

Wiring a 2-wire smoke to a DSC 1616, 1832, or 1864 is the easier of the two so we will start there. You will first take the negative wire from your first smoke detector and wire it into the PGM 2 terminal on the main DSC control board. It must go to the PGM 2 terminal and not any other PGM terminal for 2-wire smoke detectors.

View and Download Tyco DSC PowerSeries PC1616 instruction manual online. DSC PowerSeries PC1616 security sensors pdf manual download. Also for: Pc1832, Pc1864.

•Smoke detectors should always be installed in USA in accordance with Chapter 11 of NFPA 72, the National Fire Alarm Code: 11.5.1.1. : Where required by applicable laws, codes, or standards for a specific type of occupancy, approved single- and multiple-station smoke alarms shall be installed as follows: (1) In all sleeping rooms and guest rooms.

2024年2月22日 · For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion detectors or glassbreak detectors, consult the manufacturer’s literature for testing and maintenance instructions. Close all sensors (i.e. stop motion and close doors). The Ready (checkmark) indicator should be on.

1.27 Two-Wire Smoke Detectors (PC1616/1832/1864 V4.2) Panels: POWER SERIES (PC1616/1832/1864 V4.2) Overview: Two-wire smoke detectors use PGM2 of the main control panel and therefore do not take up a zone. Programming two-wire smoke detectors is a three-step process: - Program the PGM2 for two-wire smoke support - Wire the two-wire smoke detector

This equipment is capable of monitoring fire detection devices such as smoke detectors and provid-ing a warning if a fire condition is detected. Good fire detection depends on having adequate num-ber of detectors placed in appropriate locations. This equipment should be installed in accordance

Programming two-wire smoke detectors is a three-step process: – Program the PGM2 for two-wire smoke support – Wire the two-wire smoke detector. Program Sections: [009] PGM Output Programming. Step 1 – Program PGM2. In Section [009], program PGM2 as data [04] (two-wire smoke support). Step 2 – Wiring Two-wire Smoke Detectors. Connect the ...