2016年11月18日 · The job of the canister purge valve, also known as the canister purge solenoid, is to prevent vapor produced by the fuel cell from releasing into the atmosphere. This component is typically secured to the charcoal canister and the engine's vacuum system which makes up the EVAP system on most vehicles made after 1985.

2016年1月5日 · The canister purge solenoid — also referred to as an EVAP canister valve — is responsible for “purging” the EVAP system by acting as the switch that allows the vapor into the engine. When the purge solenoid fails, it will cause problems for the EVAP system, which will affect the vehicle’s emissions output levels.

Hi there. There are two different locations that the purge valve was located at, depending on the vehicle type. The first location would be on the engine intake next to the throttle body on the left side when viewing the engine from the front of the vehicle. The other location is behind the fuel tank under the vehicle next to the charcoal canister.

I posted a diagram of where the canister purge solenoid is its figure 2. Most likely from the code you have there three most likely causes a stuck open canister purge solenoid and stuck closed vent solenoid or a stuck fuel tank pressure sensor showing vacuum on the tank when there really is not. Or bad wiring to the pressure sensor.

2016年9月20日 · Step 3: Locate the EVAP canister. On most domestic and foreign vehicles sold in the US, the EVAP emissions canister is located next to the fuel cell. It is shaped in a rectangular or spherical design and has three vapor lines attached to it. One line attaches to the fuel cell, one to the EVAP purge solenoid and one to the EVAP vent solenoid.

2022年4月1日 · With the valve off, there will be 12 volts on both sides of the valve, when it is energized, the 12 volts on the other wire of the purge valve will go to ground (so around 0 volts). This is a pulse width modulated circuit, so the ECM pulses the ground side to control the solenoid.

The canister purge solenoid is located in the engine compartment. The electrical connector, vacuum and fuel vapor lines are disconnected. The defective canister purge solenoid is detached and removed. The new canister purge solenoid is installed and connected. The engine is started and checked for any vacuum and fuel vapor leaks.

2016年9月13日 · Step 3: Locate bolts and slots that hold EVAP vent solenoid. The EVAP vent solenoid is attached to the vehicle with a single bolt (or two in some cases) and is also attached to a series of slots. This is where tabs on the vent solenoid slide into for support. Step 4: Lubricate the bolts and slots with penetrating fluid. Since this component is ...

Purging the carbon canister removes the fuel vapor stored in the carbon canister. With an EEC controlled EVAP system, the flow of vapors from the canister to the engine is controlled by a EVAP Canister Purge solenoid (Figure 1) or Dual EVAP Canister Purge solenoids (Figure 2). Purging occurs when the engine is at operating temperature and off idle.

I need to replace the vapor cannister purge valve. Where is this located? Reply 1: See pretty color image attached. Reply 2: Center rear of the ...