2012年12月27日 · To access the repeater using ip address 192.168.10.1 simply disconnect the ethernet cable from repeater and connect up to other repeater you should then be able to navigate to it's ip address the same no configuration needed as the above repeater ip address is in the same subnet as the first repeater. Hope this helps.

Customer: I am trying to access 192.168.10.1 on the browser to log in to wireless N wifi repeater but the page doesn.t display Technician's Assistant: When did you last change your Wi-Fi password? Customer: I did not chane it. Technician's Assistant: Have you connected to this Wi-Fi network from a laptop or desktop (either Mac or PC) in the past?

I try to set up my WiFi repeater IP: 192.168.10.1 and can't open the page Technician's Assistant chat Customer: I try to set up my WiFi repeater IP: 192.168.10.1 and can't open the page

2009年12月28日 · I recently got a router for a wireless network. In the setup book it says to put 192.168.10.1 in the adress bar. I type it in and get Internet Explorer cannot display the webpage. I went to run>cmd and typed ping 192.168.10.1 I got this Request timed out Request timed out Request timed out Request timed out Ping statistics for 192.168.10.1

Setup Instructions: Follow the step below to setup this device: 1. Plug the WiFi Repeater into a power socket. 2. Find and connect to the new WiFi network named "Wifi-Repeater" 3. Once connected go to 192.168.10.1 in your web browser.

Customer: I have this WPS Wifi repeater with IP 192.168.10.1. Technician's Assistant: Anything else you want the Technician to know before I connect you? Customer: But as instructed, whn I log in, I can't find the Admin page Customer: What should I do? Technician's Assistant: OK. Got it. I'm sending you to a secure page to join JustAnswer.

The default IP address for Pix-Link extenders might be different depending on the model. Since yours uses 192.168.10.1, here's a refined set of steps to set up your Pix-Link WiFi extender using a web browser: Plug in and Power Up: Find a location with a good signal from your main router and plug in your Pix-Link extender.

WiFiblast Login IP: 192.168.l0.1 Wifi blast username: admin. Default password: admin. Now follow wifi blast instructions to connect host wifi access point to increase the wireless range.

Leave the username blank and use the password XXXXX admin Go to the Basic Setup page and look for Local IP Address. Change the Local IP Address to 192.168.10.1 and then go to the bottom of the page and press Save Settings. Wait 30 seconds.

Including network setup, analysis, and planning. 70,564 Satisfied Customers This question is about wifi wireless repeaters/range-extenders: I have just bought a belkin 802.11g range extender and I