More than likely there is a ground wire or neutral at least "passing" threw that switch box. Probably wire nutted and tucked away in the back. I have an occupancy sensor that requires a …

2015年3月16日 · For the top and bottom of a staircase, I want the lights to be on if either switch senses motion and the lights stay on until both switches time out after not sensing motion. I …

The green ground is NOT for safety but rather in place of neutral for the motion sensor power. According to Q&A on homedepot.com, the switch uses < 1 watt when "off". That puts in the …

2013年12月9日 · I put the motion sensor in the switch #1 position, with black as the load wire, red and white as travelers and ground. When the motion sensor is installed, it is a 3 pole motion …

All we have here is a 3-way (USA terms) switch acting as a regular switch (the black wire at the sensor is always hot) to override or control the sensor in some way through the red wire. …

Wire nut together the motion sensors so that they are in parallel and will then so provide a path to the light if either is switched on. Here is a wiring diagram (minus the grounds that must be …

2019年3月13日 · I added two images showing knob and tube wired light fixture and two wire light switch. Romex out of fixture goes to switch. Original message: I have one hot (black), one …

2015年12月22日 · These preassembled lamps often use 12VDC internally since the LED heads require it, and 12VDC motion sensor modules are much cheaper than 120VAC ones. So you'll …

2023年2月12日 · I went and bought a Lutron 2amp motion sensor switch and that too behaves in the exact same way. Works when alone, keeps running when both switches are connected. …

In that case, the motion sensor was built into a wall switch, and the switch itself was wired for 3-way. (I never took out the other switch). I've had better luck outside, with the light on my porch …